前言
本文在 12000系列器线路卡描述如 何在 IOS软件Software升级以后升级® 微码
升级线路卡固件取消 警告:老... 消息从 show version命令输出在 器 逐步
直到线路卡在允许状态
请勿使用 upgrade 命令在本文您能验证线路卡
状态用 show gsr命令有关运 行Cisco IOS软件Software版本11.2(15)gs2以上路由器参见 此信息 注意: 如果 升级ROM监控器
您 必须 重新载入线路卡 
旦Cisco IOS软 件被升级了并且路由器被重新载入了这不 意味着线路卡被升级了到最新固件 确定如 果有老版本问题使用 show version命令如下所示 注意 警告消息在下面show version命令输出 底部这些警告消息指 示什么需要被升级 mfr-2# show version
Cisco Internetwork Operating
Software IOS (tm) GS Software (GSR-P-M), Version 11.2(15)GS1a, EARLY DEPLOYMENT RELEASE
SOFTWARE (fc1)
Copyright (c) 1986-1998 by cisco
s, Inc.Compiled Mon 28-Dec-98 14:39 by tamb
Image text-base: 0x60010900, data-base: 0x606C4000
ROM:
Bootstrap, Version 11.2(9)GS5, [tamb 176] EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
mfr_2 uptime is 4 minutes
ed to ROM by reload image file is "slot0:gsr-p-mz.112-15.GS1a", booted via slot0:cisco 12008/GRP (R5000) processor (revision 0x01) with 262144K
s of memory.R5000 processor, Implementation 35, Revision 2.1 (512KB Level 2 Cache)
Last re
from power-on1 Clock Scheduler Card(s)
1 Quad-port OC3c ATM controller (4 ATM).
1 Single-port OC12c ATM controller (1 ATM).
1 four-port OC3 POS controller (4 POS).
1 Ethernet/IEEE 802.3
erface(s)5 ATM network
erface(s)4 Packet over SONET network
erface(s)507K
s of non-volatile configuration memory.20480K
s of PCMCIA card at slot 0 (Sector size 128K).8192K
s of ernal SIMM (Sector size 256K).Configuration register is 0x102
WARNING: Old Rom Monitor in slot 0
Use "upgrade rom-monitor" command to update the image
WARNING: Old Fabric Downloader in slot 0
Use "upgrade fabric-downloader" command to update the image
WARNING: Old Rom Monitor in slot 1
Use "upgrade rom-monitor" command to update the image
WARNING: Old Fabric Downloader in slot 1
Use "upgrade fabric-downloader" command to update the image
WARNING: Old Rom Monitor in slot 2
Use "upgrade rom-monitor" command to update the image
WARNING: Old Fabric Downloader in slot 2
Use "upgrade fabric-downloader" command to update the image
从以上警告消息
我们能发现我们需要升级ROM监控器和矩阵使用 show diag 命令确定什么线路卡您升级和其当前状态
注意线路卡在 个允许状态(IOS RUN)如显示在下面 show diag命令输出当 线路卡在个允许状态时您能升级固件mfr_2#show diag 0
SLOT 0 (RP/LC 0 ): 4 Port Packet Over SONET OC-3c/STM-1 Multi Mode
MAIN: type 33, 800-2396-02 rev A0 dev 16777215
HW config: 0x01 SW key: FF-FF-FF
PCA: 73-2147-05 rev A0 ver 4
HW version 1.1 S/N CAB02040049
MBUS: MBUS Agent (1) 73-2146-06 rev A0 dev 0
HW version 1.1 S/N CAB014600ME
Test hist: 0xFF RMA#: FF-FF-FF RMA hist: 0xFF
DIAG: Test count: 0xFFFFFFFF Test results: 0xFFFFFFFF
MBUS Agent Software version 01.35 (RAM) (ROM version is 01.33)
Using CAN Bus A
ROM Monitor version 0E.00
Fabric Downloader version used 00.13 (ROM version is 11.03)
Board is analyzed
Board State is Line Card Enabled (IOS RUN )
Insertion time: 00:00:11 (00:04:16 ago)
DRAM size: 268435456
sFrFab SDRAM size: 67108864
sToFab SDRAM size: 67108864
s下
个步骤将升级线路卡执行此使用 upgrade命令 下面是 upgrade命令选项 列表 mfr_2#upgrade ?
all all GSR rom images
fabric-downloader fabric downloader
mbus-agent-rom mbus agent rom
post Power _disibledevent=
SLOT 1:Upgraded linecard fabric loader successfully
EEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEppppppppppppppppppvvvvvvvvvvvvvvvvvv
SLOT 2:Upgraded linecard fabric loader successfully
Upgrading the MBUS agent rom on slot 0
rom programmed successfully with 255 retries
Upgrading the MBUS agent rom on slot 1
rom programmed successfully with 255 retries
Upgrading the MBUS agent rom on slot 2
rom programmed successfully with 255 retries
Upgrading the MBUS agent rom on slot 17
rom programmed successfully with 255 retries
Upgrading the MBUS agent rom on slot 24
rom programmed successfully with 255 retries
Upgrading the MBUS agent rom on slot 7
rom programmed successfully with 255 retries
Upgrading grp rom in slot 7
The current revision of GRP ROM is: 175
The
revision of GRP ROM will be: 175NOTE:
1) GRP ROM upgrade typically takes 30 to 240 seconds.
2) After GRP ROM upgrade the GRP will be re
.Continue GRP ROM upgrade? [yes/no]: n
注意: 在本例中
GRP ROM当前修正和新修
最新评论